ProBoat PRB08001AU Instruction Manual download pdf (Page 10)

Impulse 9 • Blackjack 9





• Install fully charged batteries in your boat and

transmitter

• Connect the boat’s battery to the ESC

• Make sure the boat is bound to the transmitter

(otherwise, bind the boat to the transmitter using

the included binding instructions)

• Make sure all linkages move freely on the boat

• Ensure the motor mount is secured to the hull so that

the motor does not move

• Perform a Control Direction Test with the transmitter

• Adjust the steering rate on your transmitter as desired

• Find a safe and open boating area

• Plan a safe boating route for the water and

wind conditions



• Always power off the receiver before powering off

the transmitter to maintain control of the boat and

to retain transmitter binding

• Disconnect the battery from the receiver and remove

the battery from the boat

• Fully dry the inside and outside of the boat, including

the water cooling system. Remove the hatch before

storing your boat

• Repair any damage or wear to the boat

• Lubricate the driveshaft

• Make note of lessons learned from the trimming of

your boat, including water and wind conditions

 The hook and loop strips in the boat retain water.

To dry them, press on them with a dry cloth. Use a

sponge, paper towel or cloth to remove water from

inside the hull.

 When you are finished boating, never leave

the boat in direct sunlight or in a hot, enclosed area

such as a car. Doing so can damage the boat.



1. Remove the nut, screw, breakaway pin and rudder

from the mount.

 The pin is designed to break in case

of rudder impact. If broken, replace the pin with

a wood pin (such as a toothpick).

2. Assemble in reverse order.

 Do not over tighten the rudder screw.

The rudder must be allowed to rotate with some

resistance in order to prevent damage to the rudder

and/or hull if the rudder comes in contact with an

object.



1. If necessary, use a tool to loosen and tighten

the nut.

2. Remove the nut and propeller from the

driveshaft.

3. Assemble in reverse order. Correctly align the

propeller with the drive dog on the driveshaft.



  

Boat will not respond

to throttle but responds

to other controls

Throttle servo travel is lower than 100% Make sure throttle dual rate is turned up to 10

Throttle channel is reversed Reverse throttle channel on transmitter

Extra noise or extra

vibration

Damaged propeller, shaft or motor Replace damaged parts

Propeller is out of balance Balance or replace propeller

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

ProBoat PRB08001AU Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Toys & accessories ProBoat PRB08001AU